6 Tips On How To Avoid CCTV Blind Spots

0
593

There are several problems which can occur with closed-circuit television. Each one of these problems can put people and their possessions at risk from burglars and other types of criminals. For example, faulty wiring or incorrect installation may cause images to be blurry or become frozen. This can make it very hard to detect people who are breaking in, and it may be difficult to prosecute if no clear images of their face can be produced.

As well as faulty images, there is a risk of blind spots with CCTV systems in Perth. Blind spots occur when the cameras do not cover the entirety of the outside and inside of the property. This gives burglars and other criminals to hide undetected in certain places and may allow them to gain access to the property or escape without being noticed until it is too late.

There are several ways to make sure that this unfortunate situation is avoided and that the cameras cover the full scope of the property. Read this helpful guide in order to find out a lot of helpful information. This could potentially prevent a burglary or something worse from happening.

Install Multiple Cameras Inside And Outside The Property

The easiest way to make sure that blind spots are avoided is to install as many cameras as possible both inside and outside the property. This will ensure that as much ground is covered by the cameras and there are no places that people will be able to hide from the cameras. www.castlesecurity.com.au has multi-camera systems.

Check The Scope Of The Cameras

Some cameras will be higher quality than others. This means that they will have a wider lens and will be able to cover more ground. People need to make sure that they choose cameras with a wide scope. This will allow for maximum coverage and will cover all of the property both inside and out.

Ensure That The Cameras Can Pivot Fully

In order to provide maximum protection and to prevent blind spots, cameras should be able to pivot with a remote-control system. People should check that the cameras pivot fully, and replace them if they appear to get stuck for any reason. Once the cameras have been replaced, they should be able to pivot fully with no problems, giving an uninterrupted 180-degree view for the people watching.

Ensure That Cameras Can Zoom Fully

The room function on CCTV is incredibly important. If the zoom is not working correctly, people may be able to hide out of sight further away.

Ensure That Cameras Don’t Flicker

Flickering cameras may create blind spots because the images are not clear. Make sure that the camera images are extremely well-defined.

Ensure That Images Don’t Freeze

Cameras which freeze effectively create blind spots because people are able to move without being detected. Fix these cameras so they don’t freeze.

Ensure That Cameras Don’t Get Stuck On A Loop

Cameras can get stuck in a loop where the same few seconds of footage plays. People will be able to get past these cameras. Fix the cameras so they don’t loop at all.

Use this guide to stop CCTV blind spots.